| HARYK |
 Posted: 12/04/2006 at 1:57 PM Post subject: using steel to connect neck and bridge |
|
|
has anyone experimented with using steel to connect the neck to the bridge in guitar construction? I was considering using plate steel to bolt a neck to and have the plate travel rearward to a steel riser that mounts the bridge..,, 1/4 plate steel, or maybe a smaller guage with side rails, making an "H" pattern..,
|
|
Back to top
|
|
|
|
Disclosure: Any links to eBay or Amazon.com are affiliate links. Affiliate links may provide commission payments to the site based on purchases.
|
|
|
| Kevin |
| Posted: 12/04/2006 at 6:12 PM Post subject: |
|
|
It should work just fine, but steel gets really heavy really fast. I would lighten it as much as possible by channeling the H shape. Strength shoudnt even be an issue with steel. Good luck.
|
|
Back to top
|
|
|
|
|
|
|
